|Technical data sheet|
Pickling of stainless steel surfaces and welding seams in one operation.
For use under extreme conditions and with materials with higher integrity.
A clean metallic surface in the application area is obtained.
Apply the pickling spray gel with a special InoTec pump via hand valve with fine spray nozzle to the
surfaces that are to be treated. The product is intrinsically viscous and adheres to vertical and overhanging sufraces.
Attention: welding seams and heat-affected zones must be allowed to cool down before using the product.
Surfaces must be free from grease and organic contamination.
If necessary, use InoTec Surface Cleaner P or InoTec Degreaser ES before the pickling process.
Read the packing label before use and follow the instructions.
Approx. 4 – 6 m2/kg InoTec Pickling Spray Gel Extra Special.
30 – 120 minutes
Dependent on the material quality, welding process, component and ambient temperature.
Optimal pickling temperature: 18°C – 22°C.
Cold high pressure water (min. 140 bar).
Rinse until rinsing water is neutral (to be checked with indicator paper).
InoTec Passivation Agent PV for immediate development of the passive layer.
The product and the rinsing water must not be lead into the sewage system.
The product and the rinsing water must be disposed of according to legal requirements (hazardous waste).
Treatment in neutralisation plant or disposal by an authorised company is mandatory.
Local statutory regulations must be followed.
The product contains hydrofluoric acid and nitric acid (C, corrosive, T+, toxic).
Follow safety advice and instructions from EC safety data sheet.
Corrosive liquid, toxic. not noted otherwise.
UN-No. 2922, class 8 (6.1) / PG II. ADR/RID
Canister 10 kg Item-No.: 89-997-15
Canister 20 kg Item-No.: 89-997-17
Canister 30 kg Item-No.: 89-997-18
Barrel 200 kg Item-No.: 99-997-19
IBC 1000 kg Item-No.: 99-997-20
Caree-Chemie GmbH, Hüttenstrasse 31,